Titanium rod filter, titanium rod is made of sintered titanium powder, its solid-liquid separation of filtering products, as well as particles, heat, high definition, good mechanical and physical properties and other characteristics. Mainly used to replace traditional mold club filters in the production of infusion solutions to remove liquid carbon dioxide. After long-term use, it reflects good results, and various technical indicators meet the requirements of GMP and Pharmacopoeia.
Matters needing attention when using titanium rod filter:
1 Collision avoids scratches, dust and grease.
2 When working pressure should not exceed the rated working pressure.
3 In normal use, at least 3-5 minutes of low voltage start-up time, their relative differential pressure should be controlled below 0.5 m p a and then gradually transferred to normal working pressure (maximum pressure does not exceed 0.4Mpa).
This product's 4 runs to a period of time later, may be due to clogging of the filter element, resulting in reduced pressure and flow, which requires backwashing or backwashing naturally. Regeneration cycle as rated pressure and flow,
